Instruction Manual

6X Series Liquid-Cooled Transmitter Chapter 3, Installation, Set Up and
Problem Identification Procedures
Instruction Manual, Rev. 0 3-1
Chapter 3
Installation and Setup Procedures
As part of the installation of the 6X transmitter, it will be necessary to plan for mechanical,
electrical, and plumbing issues. It is a good idea to spend the time to review the site
drawing, the RF system requirements, the racking plan of the transmitter cabinets, the
plumbing diagram which includes the pump package, and the heat exchanger, before
installing this equipment. Site drawings should have been generated for the particular
transmitter and the site that it is to be installed that will help in the positioning of the
equipment.
6X Typical System Floor Plan