Specifications

Date:26-JULY-2020
Page: 37
17.5 Network Event
Event Action LED Buzzer
Sound
Remark
Inclusion / Exclusion Processing Yell ow flashing n/a In processing, LED keep flashing until event finished
Factory
Default Reset
1
st
phase Built-in Leak sensor Red flashing 1 time Waked up and 3-axis sensor is ready. In Standalone mode.
2
nd
phase 3-axis sensor Green ON x1 1 time Waked up and 3-axis sensor is ready. In Mesh Network
Mode
OTA FW
Upgrade
Starting OTA upgrade
procedure
Green flash x2 2 times Being to start OTA firmware upgrade
Processing GàYàR
flashing
n/a OTA is in progressing, LED keep flashing until OTA
finished.
17.6 Battery Status
Event Action LED Buzzer
Sound
Remark
Battery Level Full Battery Level
check by 3-axis
sensor procedure
Green flash x3 3 times Battery level is full. “over 60%”
Fair Yellow flash x3 3 times Battery level is fair. “between 30% to 60%”
Low Red flash x3 3 times Battery level is low “under 30%”
17.7 Water Leak Alarm Status
Event Action LED Buzzer
Sound
Remark
Water Leak
Alarm
Normal Trigger Water
Detection Probe
Yellow x1 @ sec 1 time @ second Buzzer keeps beep sound continually at 1 sound per second.
Saving mode Green x1 @ sec 3 times only Only 3 beep sounds in first 3 seconds at 1 sound per second.