Specifications

Date:26-JULY-2020
Page: 17
12 SETUP Z-WAVE NETWORK
12.1 Check Network Status:
- By default, Custos WWD does not belong to any Z-Wave Network, before adding WWD into Z-Wave Network, you have to make sure
Custos WWD is in Standalone Mode, otherwise you have to perform Factory Default Reset refer to 12.4,
Ø
If it’s not in Standalone Mode, please perform “Factory Default Reset - refer to 12.4” or “Remove it from Z-Wave Network – refer to 12.3”
12.2 Add Custos WWD into Z-Wave Network:
- Custos WWD supports Security 2 Command Class while a Security S2 enabled controller is needed. It supports Smart Start and Classic
Inclusion,
- For adding Custos WWD into Z-Wave Network, end-user can use Smart Start for Classic Inclusion,
12.2.1 Smart Start:
- To enable Smart Start, below methods can be used
i. Scan the Z-Wave QR Code or entering PIN Code or DSK String into S2 Enabled Gateway, please refer to item 16.11 Smart Start
Labeling,
ii. Wakeup Custos WWD by shaking it until the Yellow LED ON and Buzzer Sound x1,
Ø To enable Security S2 in Z-Wave Gateway, please refer to Gateway’s user manual.
Setup In Gateway
Setup In End-Device
Network Status Check