Specifications

Date:26-JULY-2020
Page: 14
9 SETUP & PHICAL INSTALLATION
9.1 Activate WWD from Shipping Mode (For Brand New WWD only)
i. To tr igg er Built-in Water Detection Probe for 10 seconds with YELLOW LED flash 10 times, “Figure A”
ii. Until the success UI signal show up, “Green LED & Buzzer sound 1 time”
9.2 Connect the Remote Sensor Probe (Optional)
i. Remove Dust Cover. ( Please do not remove Dust Cover if Remote Sensor Probe not installed ) “Figure B”
ii. Insert the 3.5mm jack of Remote Water Detection Probe tightly. “Figure C”
iii. Place the Custos WWD on the floor horizontally
Ø Trigger Built-in Leak Sensor
Dust
Cover
Figure C
Figure A
Figure B