Reference Manual

18
www.ubisys.de

If the grantee markets their product as being Part 15 Subpart B compliant (when it also contains
unintentional-radiator digital circuity), then the grantee shall provide a notice stating that the final host
product still requires Part 15 Subpart B compliance testing with the modular transmitter installed
11.1.1. FCC Labelling Requirements
When integrating the M7B-Q95-B into a product it must be ensured that the FCC labelling
requirements are met. This includes a clearly visible label on the outside of the finished product
specifying the ubisys technologies GmbH FCC identifier (FCC ID: 2AWGH-M7B-Q95-B) as well as
Transmitter Module FCC ID: 2AWGH-M7B-Q95-B 2AWGH-M7B-Q95-B
although any similar wording that expresses the same meaning may be used.
Industry Canada (IC) Approvals
The ubisys technologies GmbH M7B-Q95-B with integrated antenna has been tested to comply with
IC.
IC: 26146-M7BQ95B
PMN: BLEnd/Z M7B-Q95B
HVIN: B4
 Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
 This module complies with FCC and Industry Canada RF radiation exposure limits set forth for
general population. To maintain compliance, this module must not be co-located or operating in
conjunction with any other antenna or transmitter.
The labelling requirements for Industry Canada are similar to those of the FCC. Again a clearly visibly
Transmitter Module, IC: 26146-M7BQ95B wording that expresses the same
meaning may be used.
The integrator is responsible for the final product to comply to IC ICES-003 and FCC Part 15, Sub. B
Unintentional Radiators
L'ubisys technologies GmbH M7B-Q95-B avec antenne intégrée a été testé pour être conforme à IC.
IC : 26146-M7BQ95B
PMN : BLEnd/Z M7B-Q95B
HVIN : B4