Reference Manual

10
www.ubisys.de

5. MOUNTING
M7B-Q95-B
The M7B-Q95-B module was designed for horizontal or vertical mounting. Based on the application
one of these can be chosen. On boards where large components could affect the antenna
performance the vertical mounting offers a second option.
Horizontal Mounting
In a horizontal position the module is soldered in by using the soldering pads on the left and right side.
All pads are designed to solder the module by hand or reflow.
When mounted in horizontal position there are two mandatory keep-out areas. One area is needed for
the antenna, the second area clears the area of the bottom mounting pads for vertical mounting on the
short side of the module.
The antenna keep-out applies to all layers of the base board. There shall not be any components,
traces, pads or copper areas in any layer within the keep-out area or metal parts, housings or screws
close to it.
Vertical Mounting