User's Manual

Ubisense – Ultra-wideband Location System – Ubisensor V2.0
WARNING: Never plug a networking cable into a timing cable socket, or a timing cable into the
networking socket!
Switching on the Ubisensor
To turn on a Ubisensor, simply turn on the power to the device. The LED on the front of the
Ubisensor should illuminate, and the device will begin to attempt to contact the Ubisense location
system (which should already have been installed on your network – see the software manual for
details). Configuration of the Ubisensor is entirely automatic, and is under the control of the
Ubisense location system.
Calibrating the Ubisensor
When the Ubisensor has been installed in its final location, its position and orientation must be
found and entered into the Ubisense location system’s database. The Ubisense location system
management tools make this calibration process simple and quick – refer to the software manual
for details.
12V DC
12V DC
12V DC
MASTER
UNIT
SLAVE
UNIT
SLAVE
UNIT
To
network
To
network
To
network
Cat. 5 unshielded (or better)
Cat. 5e shielded (or better)