Download

38
HDD Replacement
The Cloud Key Gen2 Plus comes pre-installed with a 1TB SATA HDD.
If you want to replace it, you must use a 2.5” SATA HDD and follow
these instructions:
1. Back up your controller configurations. Controller
configurations are stored on the hard drive and will be
reset when a new hard drive is inserted.
2. Power off the Cloud Key Gen 2 Plus to prevent any
software disruption.
3. On the bottom of the Cloud Key Gen 2 Plus, slide the HDD
Latch to release the HDD tray.
WARNING: Do not release or operate the HDD Latch
while the Cloud Key Gen2 Plus is in use or powered on.
4. Gently flex the sides of the tray to release the drive and
remove the drive from the tray.