Quick Start Guide

2
EdgeRouter
™
Lite Quick Start Guide
Hardware Overview
Front Panel Ports
eth0 eth1 eth2
Console
ResetEthernet (eth0-eth2)
Interface Description
Console
RJ45 serial console port for Command Line Interface
(CLI) management. Use a RJ45-to-DB9, serial console
cable, also known as a rollover cable, to connect the
Console port to your computer. (If your computer
does not have a DB9 port, then you will also need a
DB9 adapter.) Then configure the following settings
as needed:
• Baud rate 115200
• Data bits 8
• Parity NONE
• Stop bits 1
• Flow control NONE
Ethernet
(eth0-eth2)
10/100/1000 Mbps Ethernet ports.
Reset
There are two methods to reset the EdgeRouter to
factory defaults:
• Runtime reset (recommended) The EdgeRouter
should be running after bootup is complete. Press
and hold the Reset button for about 10seconds
until the right LED on port eth2 starts flashing
and then becomes solidly lit. After a few seconds,
the LED will turn off, and the EdgeRouter will
automatically reboot.
• Power-on reset Disconnect the Power Cord from
the Power Adapter. Press and hold the Reset
button while connecting the Power Cord to the
Power Adapter. Keep holding the button until the
right LED on port eth2 starts flashing and then
stops flashing after a few seconds.