User's Manual

© 2010 - 2015 Persistent Systems, LLC – All Rights Reserved68
WEB MANAGEMENT INTERFACE REFERENCE
PUSH-TO-TALK CONFIGURATION
MENU ITEM MENU ITEM DESCRIPTION
Run PTT subsys-
tem
Enables or disables push-to-talk voice
Volume Defines the default earpiece volume for headsets - Valid values are 0
through 125 (Values above 100 are digitally amplified)
Microphone Level Defines the default microphone level for headsets - Valid values are 0
through 100 or “auto.” The “auto” configuration uses automatic gain
control for microphone input and is recommended for most users.
Transmit Mode
Transmit on
keypress
Audio is transmitted only when the PTT button is pressed on the
headset.
Transmit continu-
ously
Audio is continuously transmitted. Other nodes may monitor the
channel only. Selected Channel audio transmissions will interrupt
monitored continuously transmitted audio.
Tones on Transmit
Enables or disables an audible checktone (either Beeps or Verbal) at
the beginning of each transmitted message
Tones on Receive Enables or disables an audible checktone (either Beeps or Verbal) at
the beginning of each received message
Advanced Fea-
tures
If advanced features are able to be configured, a drop down menu will
appear. If advanced features are not able to be configured, a string
will appear displaying the current configuration. Available features vary
among Wave Relay
®
hardware versions.
Silynx PTT Head-
set
Enables the serial port on the node (Silynx PTT Headsets require this
setting be enabled)
Microphone
Voltage
Enables +5V power supply voltage on the center pin of the 6-pin head-
set connector (required for some headsets)