User's Manual

© 2010 - 2015 Persistent Systems, LLC – All Rights Reserved66
INITIAL COORDINATE SETTINGS
These fields allow specification of the
initial antenna target location in cases
where coordinates have not yet been
received from the tracked node.
WEB MANAGEMENT INTERFACE REFERENCE
MENU ITEM MENU ITEM DESCRIPTION
Initial Latitude Sets the tracked node’s initial latitude in decimal degrees
Initial Longi-
tude
Sets the tracked node’s initial longitude in decimal degrees
Initial Altitude Sets the tracked node’s initial altitude in feet above GPS ellipsoid, which is
approximately equal to feet above mean sea level (MSL)
FINE TUNING SETTINGS
MENU ITEM MENU ITEM DESCRIPTION
Compass
Tweak
Defines the heading correction factor for tracking, specified in decimal
degrees - Use a positive number for right/clockwise correction and a
negative number for left/counterclockwise correction.
Elevation
Tweak
Defines the elevation correction factor for tracking, specified in decimal
degrees - Use a positive number for upward correction and a negative
number for downward correction.
CoT UDP Port Defines the port number to receive coordinate updates via an external
CoT feed
CDF UDP Port Defines the port number to receive coordinate updates via an external
CDF feed
Compass Read-
ing
Specifies the heading of the Pan/Tilt unit - The heading is defined as the
compass reading taken when standing behind the Pan/Tilt unit while fac-
ing the large circular electrical connector. For more information, see the
compass reading step of the setup procedure.