User's Manual

WEB MANAGEMENT INTERFACE REFERENCE

POSITION

The node’s position must be speciﬁed in order

to provide data to the visualization, CoT, and

tracking features. The position may be speciﬁed

via internal or external GPS, manually, or from an

external feed.

Position Mode:

MENU ITEM MENU ITEM DESCRIPTION

Determines the source of local positioning information

Use Internal GPS Instructs node to receive GPS position information from the optional

integrated GPS module - This control should not be enabled on a device

that does not have an integrated GPS module or if a suitable GPS

antenna with satellite connectivity is not attached.

Use External

GPS

Instructs node to receive GPS position information from an external GPS

device connected via the node’s onboard serial port - A standard NMEA

data stream is supported with the following RS-232 settings: 4800 baud,

8-N-1, no ﬂow control. Higher baud rates are also autodetected. Note that

this option is disabled on Wave Relay

units without serial connectors or

units already using the serial port for other features (e.g. antenna tracking).

Manual Entry Allows manual entry of latitude, longitude, and altitude.

Use External

Feed

Instructs node to receive positioning information over the network via

the external Wave Relay

‘wr-update-gps’ command

Use ESD Feed Instructs node to receive positioning information over the network via a

ESD (Exploitation Support Data) feed

Use CoT Feed Instructs node to receive positioning information over the network via a

CoT (Cursor on Target) feed. This feature is not available on all ﬁrmware

versions.

Use CDF Feed Instructs node to receive positioning information over the network via

Shadow CDF (Common Data Feed)

GPS Status Displays the current status of the GPS (only visible in “Use Internal GPS”

mode)