User's Manual

STEPS FOR CONFIGURING THE FIRST NODE

All nodes arrive set to factory default conﬁguration. This section details the

recommended setup and custom conﬁguration procedure for a set of identical

nodes, for example, a set of 50 MPU4s. In general, the procedure is completed as

follows:

1. Conﬁgure an individual node

2. Save the individual node’s conﬁguration settings and key

3. Load key and the saved conﬁguration settings into remaining nodes

4. Verify communication among the nodes

QUICK CONFIGURATION

If the network administrator provides a node conﬁguration ﬁle, use it to facilitate

quick device conﬁguration. Please refer to Section “Quick Setup.” If a node con-

ﬁguration ﬁle has been provided, skip to the “Steps for Conﬁguring the Remaining

Nodes” section.

INITIAL NODE CONFIGURATION

STEPS FOR CONFIGURING THE FIRST NODE

1. Conﬁgure Network Defaults

2. Customize Node Name and IP Address To Be Unique

3. Conﬁgure Radio to Use Defaults

4. Setup Node List

5. Store Conﬁguration File

6. Set and Save Security Settings