720p Indoor/Outdoor IP Camera with Infrared Model: UVC
Introduction Thank you for purchasing the Ubiquiti Networks™ UniFi® Video Camera. This Quick Start Guide is designed to guide you through the installation of the UniFi Video Camera and show you how to access the Camera Configuration Interface. This Quick Start Guide also includes the warranty terms. The UniFi Video software and User Guide are available for download at downloads.ubnt.com/unifivideo Package Contents Camera PoE Adapter (24V, 0.
Hardware Overview Side View Sun Shade Adjusts Camera Up or Down Rotates Camera Rotates Base Bottom View Ethernet Seal Port Cover LEDs Video Camera microSD Card Slot M/N: UVC 24V 0.5A POE Ethernet Port LEDs Ethernet The Ethernet LED will light steady green when an active Ethernet connection is made and flash when there is activity. Power The Power LED will light steady amber when the camera is connected to a power source.
Before You Begin A few notes about the camera before you begin installation: • If you wish to use the sun shade, it is easier to engage before you install the camera. • The camera has an adjustable base, tilt, and camera rotation. • The camera should never be pointing straight up or straight down. Always ensure it is at least two clicks from the straight up or down position. • When mounted outdoors, there should be a 150 mm (6") drip loop to prevent water from creeping along the cable to the camera.
Sun Shade If you want to use the Sun Shade, press the Sun Shade Lock and Release Tab from behind the camera and slide the Sun Shade forward until it locks into place.
Installation Overview The installation process differs depending on if you are mounting the camera on a pole or on a wall. Follow the instructions for the installation that you are performing. Below is an overview of the steps: • Connect one end of the Ethernet cable to the camera. • Insert a microSD card (optional). • Perform the camera mounting steps (Wall Mount or Pole Mount). • Connect the other end of Ethernet cable to the PoE Adapter or a Ubiquiti Networks TOUGHSwitch™.
3. Connect an Ethernet cable to the Ethernet port on the camera. Video Camera M/N: UVC 24V 0.5A POE 4. Remove the Ethernet Seal from the Port Cover. 5. Slide the Port Cover back onto the camera near the Ethernet port and snap it in place. 6. Wrap the Ethernet Seal around the Ethernet cable and press it into the Port Cover.
Wall Mount 1. Remove the adhesive Mounting Template from the backing and place the label on the wall where you want the camera. 2. Use a 7 mm drill bit to drill the holes in the wall. 3. Insert the four Screw Anchors into the wall. 4. Use a Phillips screwdriver to secure the camera to the wall with the four Screws. Proceed to Connecting Power over Ethernet.
Pole Mount To mount the UniFi Video Camera on a pole, use the included Metal Strap: 1. Open the Metal Strap by turning the locking screw counter‑clockwise. 2. Slide the Metal Strap through the base of the camera. 3. Wrap the Metal Strap around the pole. Use a screwdriver or 7 mm socket drive to turn the locking screw clockwise and securely fasten the strap to the pole.
Connecting Power over Ethernet 1. Connect the other end of the Ethernet cable to one of the following: • PoE Adapter Connect the UniFi Video Camera to the Ethernet port labeled POE on the included PoE Adapter. • EdgeSwitch (shown below) or TOUGHSwitch Connect the UniFi Video Camera to a port with 24V power enabled and skip steps 2 and 3.
2. Connect an Ethernet cable from your LAN to the Ethernet port labeled LAN on the PoE Adapter. 3. Connect the power cord to the power port on the PoE Adapter. Connect the other end of the power cord to a power outlet.
UniFi Video The UniFI Video software is pre-installed on the UniFi NVR (sold separately). If you do not have the UniFi NVR, you can download and install the latest version of the UniFi Video software at downloads.ubnt.com/unifivideo; the UniFi Video auto-management feature should automatically detect and install your new camera(s). Proceed to Adjusting the Camera View. For details on using the UniFi Video software, refer to the User Guide at documentation.ubnt.
Camera Configuration Interface Access the Camera Configuration Interface if you have not yet installed the UniFi Video software, or plan to use the UniFi Video Camera as a stand‑alone camera without the UniFi Video software. 1. Ensure that your host machine is connected to the same LAN as the UniFi Video Camera. 2. The UniFi Video Camera is set to DHCP by default.
5. The Main screen will appear and you should see a live video stream from the UniFi Video Camera. Adjusting the Camera View Adjust Camera Up or Down Rotate Camera Rotate Base Note: Remove the protective plastic film from the camera lens and IR LEDs. For details on using the UniFi Video software, refer to the User Guide at: documentation.ubnt.
Specifications UniFi Video Camera Dimensions 225 x 75 x 75 mm (8.85 x 2.95 x 2.95") Weight Ports 373 g (13.1 oz) (1) 10/100 Ethernet Port, microSD Card Slot Sensor Progressive Scan RGB CMOS ¼" Lens 3.6 mm/ F1.8 Power LED Amber Link/Activity LED Green Buttons Power Method Factory Reset Button Passive Power over Ethernet (12-24V) Power Supply 24V, 0.5A PoE Adapter Included Max. Power Consumption 4.
Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in location that can be submerged by water. WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning. Electrical Safety Information 1.
Limited Warranty UBIQUITI NETWORKS, Inc (“UBIQUITI NETWORKS”) warrants that the product(s) furnished hereunder (the “Product(s)”) shall be free from defects in material and workmanship for a period of one (1) year from the date of shipment by UBIQUITI NETWORKS under normal use and operation.
Disclaimer EXCEPT FOR ANY EXPRESS WARRANTIES PROVIDED HEREIN, UBIQUITI NETWORKS, ITS AFFILIATES, AND ITS AND THEIR THIRD PARTY DATA, SERVICE, SOFTWARE AND HARDWARE PROVIDERS HEREBY DISCLAIM AND MAKE NO OTHER REPRESENTATION OR WARRANTY OF ANY KIND, EXPRESS, IMPLIED OR STATUTORY, INCLUDING, BUT NOT LIMITED TO, REPRESENTATIONS, GUARANTEES, OR WARRANTIES OF MERCHANTABILITY, ACCURACY, QUALITY OF SERVICE OR RESULTS, AVAILABILITY, SATISFACTORY QUALITY, LACK OF VIRUSES, QUIET ENJOYMENT, FITNESS FOR A PARTICULAR PUR
Note Some countries, states and provinces do not allow exclusions of implied warranties or conditions, so the above exclusion may not apply to you. You may have other rights that vary from country to country, state to state, or province to province. Some countries, states and provinces do not allow the exclusion or limitation of liability for incidental or consequential damages, so the above limitation may not apply to you.
Industry Canada This Class A digital apparatus complies with Canadian CAN ICES-3(B). To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: 1. This device may not cause interference, and 2.
RoHS/WEEE Compliance Statement English European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams. It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by the government or local authorities.
Español La Directiva 2002/96/CE de la UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
Declaration of Conformity Česky [Czech] UBIQUITI NETWORKS tímto prohla uje, e tento UBIQUITI NETWORKS device, je ve shod se základními po adavky a dal ími p íslu n mi ustanoveními sm rnice 1999/5/ES. Dansk [Danish] Undertegnede UBIQUITI NETWORKS erklærer herved, at følgende udstyr UBIQUITI NETWORKS device, overholder de væsentlige krav og øvrige relevante krav i direktiv 1999/5/EF.
Lietuviškai [Lithuanian] UBIQUITI NETWORKS deklaruoja, kad šis UBIQUITI NETWORKS įrenginys atitinka esminius reikalavimus ir kitas 1999/5/EB Direktyvos nuostatas. Malti [Maltese] Hawnhekk, UBIQUITI NETWORKS, jiddikjara li dan UBIQUITI NETWORKS device, jikkonforma mal- ti ijiet essenzjali u ma provvedimenti o rajn relevanti li hemm fid-Dirrettiva 1999/5/EC.
