Owners manual

50
Appendix B: Standalone Mode UniFi Video User Guide
Ubiquiti Networks, Inc.
Mode The mode of the camera: UniFi Video or Standalone.
The UniFi Video setting indicates that the camera is being
managed by UniFi Video, To go into Standalone mode,
select Standalone and click Save Changes. (If you are
prompted to unmanage the camera, do so as described in
“Unmanaging a Camera” on page 53.)
UniFi Video Server (Available in UniFi Video mode only.)
Displays the IP address of the UniFi video server.
Display Timestamp Used to enable or disable the
timestamp in the video feed. Default is Enabled.
Display Logo Used to enable or disable the logo display
in the video feed. Default is Enabled.
Enable Microphone Used to enable or disable the
microphone. Default is Enabled.
Enable RTSP Authentication Use this option to require a
user to authenticate before allowing them to view an RTSP
live stream from the camera. Check the box to enable this
option, then enter the Username and Password that will be
used for authentication.
Microphone Volume (Available only if Enable Microphone
is enabled.) Drag the slider control left or right to adjust
the microphone input level.
Camera Model Displays the model of the camera.
Mode Displays the camera mode: UniFi Video or
Standalone.
Connected To Displays the IP address of the server to
which the camera is connected.
Uptime Displays the camera’s total uptime in days, hours,
and minutes.
Video Quality
The Video Quality section of the Configure tab provides the
following information:
RTSP Stream Displays the current video resolution of
the RTSP stream: High, Medium
, or Low.
Bitrate Drag the slider control left or right to adjust the
RTSP streaming bitrate.
FPS Drag the slider control left or right to adjust the
frames per second.
In Standalone mode, the following are also displayed:
RTSP URL Displays the current URL for RTSP streaming.
Width Displays the current width of the RTSP video feed.
Height Displays the current height of the RTSP video
feed.
Bitrate Displays the current bitrate of the RTSP video
feed.
FPS Displays the current frame rate of the RTSP video
feed.
Save Changes Click this button to save changes you have
made.
Revert Click this button to cancel any changes you have
made and restore the original settings.
Show Video Click this to scroll the window up to the live
video feed.
Network Tab
The Network tab displays network-related settings for the
camera.
Configuration Mode Used to set the camera’s IP address
configuration mode to Static or DHCP.
DHCP Fallback IP Address Use this to specify the IP
address to fall back to if Configuration Mode is set to DHCP
and no DHCP server is available.
DHCP Fallback Netmask Use this to specify the IP net
mask if Configuration Mode is set to DHCP and no DHCP
server is available.
Camera IP Address Displays the camera’s IP address.
MAC Address Displays the camera’s MAC address.
Netmask Displays the camera’s IP net mask.
Gateway Displays the gateway IP address.
Primary DNS Displays the DNS server IP address.
RX Displays how much data (in Kb) the camera has
received.
TX Displays how much data (in Mb) the camera has sent.
Save Changes Click this button to save changes you have
made.
Revert Click this button to cancel any changes you have
made and restore the original settings.
Show Video Click this to scroll the window up to the live
video feed.