Owners manual

13
Chapter 2: CamerasUniFi Video User Guide
Ubiquiti Networks, Inc.
Seconds To Record Before Enter the number of seconds
you want UniFi Video to record before the triggering
motion occurs on the selected camera.
Seconds To Record After Enter the number of seconds
you want UniFi Video to record after the triggering motion
occurs on the selected camera.
Configuring a Zone
Adjustment Points
By default, the initial zone for each camera is the entire
viewing area captured in the live feed window. Click
and drag the Adjustment Points from each corner of the
window to the perimeter of the area you would like to
define as your zone. Only motion within this zone will
trigger recording.
Click to test the zone you just created and adjust
the sensitivity using the Sensitivity Slider control. Image
trails will appear when motion is detected and the
sensitivity level and motion spikes will appear in the
bottom right corner of the camera feed. The sensitivity
level is represented by the blue line. As various degrees of
motion occur, you’ll see spikes of different levels. Adjust
the sensitivity to a level that best suits your needs. Motion
spikes that exceed the defined sensitivity threshold will
be recorded when motion recording is enabled. Click Test
Zone again to stop the test.
Sensitivity Level
Motion Spike
Motion Trails
Sensitivity Slider
Click to refresh the camera image that
appears in the zone preview.
Use this button to delete the current zone.
Click an area of the camera feed to define
another zone after deleting the existing zone.
Entry Door
Enter a name or brief description of the zone
you are creating, in the text field provided. In
this example, Entry Door is used.
Click Save when you are done configuring
and naming your new zone.
Click Revert to cancel all changes and restore
the previous settings.
Stats
CPU (% Utilization) Displays the camera’s CPU utilization
recorded over 24 hours with high, low, and average points
highlighted. Red indicates the highest point, green is the
average, and blue is the lowest point during sampled
intervals.
Memory (% Utilization) Displays the percentage of the
camera’s memory utilization over a 24-hour period.
Network (Kbytes/sec) Displays the network traffic for the
selected camera over the last 24 hours. Graph is expressed
in kilobytes per second.
Disk (Mbytes) Displays the amount of disk usage for the
selected camera over the last 24 hours. Graph is expressed
in total megabytes.