Quick Start Guide

Ethernet 10/100 RJ45 port connects to an
802.3af/802.3at or 24V Passive PoE switch for
PoE power and data.
Reset Button To reset to factory defaults,
press and hold the Reset button for more than
10 seconds while the camera is poweredon.
Before You Begin
Remove the sticker from the bottom of the
Mounting Base.
Installation Overview
To install the camera, please follow the
instructions of the following sections in this
order:
1. Hardware Installation
2. Connecting Power over Ethernet
3. UniFi Video
4. Adjusting the Camera View
Hardware Installation
The camera can be mounted on a wall, ceiling,
or pole. Follow the appropriate steps for your
installation: