Quick Start Guide

Bottom View
Ethernet Port
Reset Button
Ethernet Port The Ethernet Port is a 10/100 Mbps port used
to supply power from a PoE 802.3af‑compliant switch to the
camera. The switch should be connected to a LAN running
DHCP services and the UniFi Video Controller software.
Reset Button The Reset Button is used to reset the camera to
factory defaults. Press and hold the Reset Button for more than
10 seconds while the camera is powered on.
Installation
The UVC G3 Flex can be mounted using one of the following
methods:
• Desktop For installing on a flat surface such as a desktop
or table/shelf; could be set up for temporary installations.
• Wall For installing in a secure location; used more for
stationary or permanent installations.
• Pole For installing on a pole (indoor or outdoor).
Proceed to the appropriate section for your installation.
Note: To change the viewing angle of the G3 Flex
camera at any time:
• Tilt the lens up or down for vertical adjustment.
• Turn the base left or right for horizontal adjustment