080p Indoor/Outdoor IP Camera with Infrared and 802.
Introduction Thank you for purchasing the Ubiquiti Networks® UniFi® Video Camera G3 Flex. This Quick Start Guide is designed to guide you through installation and includes warranty terms. Package Contents G3 Flex Camera Security Screw (Qty. 1) Indoor Mount Pole Mount Outdoor Cover Screws (Qty. 3) Screw Anchors (Qty. 3) Zip Ties (Qty.
Outdoor Installation Requirements IMPORTANT: When installed outdoors, the camera must be installed under an eave or other protected location. • Mounting location should be at least 60 cm (2 ft) from the edge of the eave or ceiling. • Mount the camera in the upright position only. Please see diagram below. • Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor wired Ethernet connections and should be grounded through the AC ground of the PoE.
Before You Begin The UVC G3 Flex camera is designed to work with the UniFi Video® controller software (v3.9.2 or higher). The software may be hosted on any of the following: • UniFi Application Server, model UAS-XG • UniFi NVR, model UVC-NVR-2TB • A Linux or Windows computer Note: The latest UniFi Video software is available for free download at: www.ubnt.com/download/unifivideo The UVC G3 Flex can be powered by connecting it to a PoE 802.3af-compliant switch or injector.
Hardware Overview Microphone Camera Lens Light Sensor LED Swivel Base Microphone Microphone for recording audio Camera Lens Lens for viewing/recording video Light Sensor Sensor for ambient light LED Status indicator for the following: LED State Status Alternating White/Blue Device is busy; do not touch or unplug it. This usually indicates that a process such as a firmware upgrade is taking place.
Bottom View Ethernet Port Reset Button Ethernet Port The Ethernet Port is a 10/100 Mbps port used to supply power from a PoE 802.3af-compliant switch to the camera. The switch should be connected to a LAN running DHCP services and the UniFi Video Controller software. Reset Button The Reset Button is used to reset the camera to factory defaults. Press and hold the Reset Button for more than 10 seconds while the camera is powered on.
Desktop 1. Remove the Indoor Mount from the bottom of the camera. 2. Insert one end of the RJ-45 cable into the Ethernet Port and the other end into a PoE 802.3af-compliant switch. 3. Replace the Indoor Mount by lining up the notches with the slots on the camera base and pressing it down.
4. Place the camera on any flat surface and adjust the viewing angle by: • Tilting the lens up or down for vertical adjustment • Turning the base left or right for horizontal adjustment Wall 1. If the Ethernet cable is coming from the inside of a wall: a. Drill or cut a hole in the wall and feed the Ethernet cable through the opening. b. Pull the Ethernet cable forward and slide it through the opening in the mount. 2. Use the Screws and Screw Anchors to secure the Indoor Mount to the wall.
3. Connect the Ethernet cable to the Ethernet Port on the camera. 4. Attach the camera to the Indoor Mount by lining up the notches with the slots on the bottom of the camera. Press firmly until the camera snaps on. or Horizontal Mounting Vertical Mounting Pole 1. Attach the Pole Mount to a pole using the included Zip Ties.
2. Connect an Ethernet cable to the Ethernet Port on the G3 Flex camera. Note: If you are mounting the camera outdoors, it must be installed in the upright position to prevent water from getting into the base of the camera. Use the Outdoor Cover for additional protection from moisture.
3. Attach the camera to the Pole Mount by: a. Pressing the camera against the Pole Mount and lining up the notches with the slots on the bottom of the camera. b. Slide the camera down onto the Pole Mount until it snaps into place. Note: When using the Outdoor Cover, use an Ethernet cable without strain-relief boots on the connector. This will prevent unnecessary tension on the cable ends. 4.
5. Adjust the camera to the desired viewing angle by: • Tilting the lens up or down for vertical adjustment • Turning the base left or right for horizontal adjustment Installation is complete.
UniFi Video Ensure that you are running UniFi Video software version 3.9.2 or newer. The latest version of the UniFi Video software is available at www.ubnt.com/download/unifivideo The UniFi Video auto-management feature should automatically detect your new camera(s). To manage the camera, perform the following steps: 1. Click the Unmanaged tab. 2. Click the camera row. 3. The Camera Details window will appear on the right side of the screen. Enter ubnt in the Username and Password fields and click Manage.
Specifications UVC-G3-FLEX Dimensions Ø 107.5 x 48 x 48 mm (Ø 4.23 x 1.89 x 1.89") Weight 170 g (5.99 oz) Sensor 1/2.7" 2-Megapixel HDR Sensor Lens Viewing Angle with Lens Distortion Correction (LDC) LDC Off LDC On Night Mode Video Compression Resolution Maximum Frame Rate Image Settings Microphone Management Interface Networking Interface Max. Power Consumption Power Method Power Supply Mounting Operating Temperature Operating Humidity EFL 3.4mm / f1.2 87.
Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Hot Surface. Do not touch. WARNING: Do not use this product in a location that can be submerged by water. WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning. Electrical Safety Information 1.
Limited Warranty UBIQUITI NETWORKS, Inc (“UBIQUITI NETWORKS”) warrants that the product(s) furnished hereunder (the “Product(s)”) shall be free from defects in material and workmanship for a period of one (1) year from the date of shipment by UBIQUITI NETWORKS under normal use and operation.
Disclaimer EXCEPT FOR ANY EXPRESS WARRANTIES PROVIDED HEREIN, UBIQUITI NETWORKS, ITS AFFILIATES, AND ITS AND THEIR THIRD PARTY DATA, SERVICE, SOFTWARE AND HARDWARE PROVIDERS HEREBY DISCLAIM AND MAKE NO OTHER REPRESENTATION OR WARRANTY OF ANY KIND, EXPRESS, IMPLIED OR STATUTORY, INCLUDING, BUT NOT LIMITED TO, REPRESENTATIONS, GUARANTEES, OR WARRANTIES OF MERCHANTABILITY, ACCURACY, QUALITY OF SERVICE OR RESULTS, AVAILABILITY, SATISFACTORY QUALITY, LACK OF VIRUSES, QUIET ENJOYMENT, FITNESS FOR A PARTICULAR PUR
Note Some countries, states and provinces do not allow exclusions of implied warranties or conditions, so the above exclusion may not apply to you. You may have other rights that vary from country to country, state to state, or province to province. Some countries, states and provinces do not allow the exclusion or limitation of liability for incidental or consequential damages, so the above limitation may not apply to you.
CE Marking CE marking on this product represents the product is in compliance with all directives that are applicable to it. RoHS/WEEE Compliance Statement English European Directive 2012/19/EU requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams.
Español La Directiva 2012/19/UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
Declaration of Conformity български [Bulgarian] С настоящото UBIQUITI NETWORKS декларира, че този тип радиосъоръжение UVC-G3-FLEX е в съответствие с Директива 2014/53/ЕС. Цялостният текст на ЕС декларацията за съответствие може да се намери на следния интернет адрес: www.ubnt.com/compliance Hrvatski [Croatian] UBIQUITI NETWORKS ovime izjavljuje da je radijska oprema tipa UVC-G3-FLEX u skladu s Direktivom 2014/53/EU. Cjeloviti tekst EU izjave o sukladnosti dostupan je na sljedećoj internetskoj adresi: www.
Norsk [Norwegian] UBIQUITI NETWORKS erklærer herved at utstyret UVC-G3-FLEX er i samsvar med de grunnleggende krav og øvrige relevante krav i direktiv 2014/53/EU. Den fulle teksten til EU-samsvarserklæringen er tilgjengelig på følgende internettadresse: www.ubnt.com/compliance Polski [Polish] UBIQUITI NETWORKS niniejszym oświadcza, że typ urządzenia radiowego UVC-G3-FLEX jest zgodny z dyrektywą 2014/53/UE. Pełny tekst deklaracji zgodności UE jest dostępny pod następującym adresem internetowym: www.ubnt.
www.ubnt.com ©2018 Ubiquiti Networks, Inc. All rights reserved. Ubiquiti, Ubiquiti Networks, the Ubiquiti U logo, the Ubiquiti beam logo, and UniFi Video are trademarks or registered trademarks of Ubiquiti Networks, Inc. in the United States and in other countries. Apple, the Apple logo, and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc.
