Enterprise Gateway Router with Gigabit Ethernet Model: USG
Introduction Thank you for purchasing the Ubiquiti Networks® UniFi® Security Gateway. This Quick Start Guide is designed to guide you through installation and also includes warranty terms. Package Contents UniFi Security Gateway Screws (M2.9x20, Qty. 2) Power Adapter (12V, 1A) Screw Anchors (M2.9, Qty. 2) Power Cord Quick Start Guide TERMS OF USE: All Ethernet cabling runs must use CAT5 (or above).
UniFi Controller System Requirements • Microsoft Windows 8, Mac OS X, or Linux • Java Runtime Environment 1.6 (or above) • Web Browser: Mozilla Firefox, Google Chrome, Microsoft Edge, or Microsoft Internet Explorer 11 • UniFi Controller software v4.8 or higher (available at: downloads.ubnt.
Hardware Overview Ports Panel Interface Description Console RJ45 serial console port for Command Line Interface (CLI) management. Use a RJ45‑to‑DB9, serial console cable, also known as a rollover cable, to connect the Console port to your computer. Then configure the following settings as needed: • Baud rate 115200 • Data bits 8 • Parity NONE • Stop bits 1 • Flow control NONE Reset Resets to factory defaults. The UniFi Security Gateway should be powered on.
LEDs Status Power Ethernet Console Status Indicator LED Status Speed/Link/Act State Status White Fully Booted; Not Adopted Blue Adopted and Provisioned Alternating White/Blue Device Firmware is Upgrading Blue Flashing Device Locator Activated from UniFi Controller Off Power Off Green Power On Off No Link Amber Link Established at 10/100 Mbps Amber Flashing Link Activity at 10/100 Mbps Green Link Established at 1000 Mbps Green Flashing Link Activity at 1000 Mbps Power Speed/
Hardware Installation The UniFi Security Gateway can be used on a level, stable surface, or mounted to a wall with the included screws and anchors. If you are not going to mount the UniFi Security Gateway on a wall, then skip to the section, Connecting Power. WARNING: To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. WARNING: FAILURE TO PROVIDE PROPER VENTILATION MAY CAUSE FIRE HAZARD.
2. Use a Phillips screwdriver to secure a Screw into each anchor. Leave a clearance of approximately 3 mm between the screw head and the wall. 3 mm 3. Position the UniFi Security Gateway over the Screws, and insert the Screws into the wall-mount slots located on the bottom of the UniFi Security Gateway. Then slide the UniFi Security Gateway down to lock it into place.
Connecting Power 1. Connect the Power Adapter to the power port. 2. Connect the Power Cord to the Power Adapter. Connect the other end of the Power Cord to a grounded power source.
Network Connections 1. Connect an Ethernet cable from a broadband modem or WAN to the WAN port. 2. Connect an Ethernet cable from a network switch to the LAN port. Note: The LAN port is set to DHCP Server by default.
Software Installation Download and install the latest version of the UniFi Controller software at: downloads.ubnt.com/unifi From a management station connected to the same Layer‑2 network, launch the installer and follow the on-screen instructions. Note: If you already have UniFi Controller v4.x or higher installed, go to the section, Adopting the UniFi Security Gateway. 1. The Ubiquiti UniFi Controller window will appear. Click Launch a Browser to Manage the Network. 2.
3. The UniFi Controller will discover the UniFi Security Gateway with the default IP Address,192.168.1.1. Select the device, and click Next. 4. Create an SSID (wireless network name) and Security Key. Click Next. If you do not have any UniFi APs on the network, click Skip.
5. Create an Admin Name and Password for super admin access to the UniFi Controller. Confirm the Password, and click Next. 6. Review the UniFi Controller settings. Click Finish to complete the UniFi Setup Wizard.
7. The login screen for the UniFi Controller will appear. Enter the Admin Name and Password that you created in the UniFi Setup Wizard. Click Login. The UniFi Controller dashboard window will appear. Adopting the UniFi Security Gateway 1. From the UniFi Controller dashboard, click Devices in the left menu bar.
2. In the Devices window, locate UniFi Gateway in the list of devices under the Model column. To adopt and provision the gateway, click Adopt. 3. The Status Indicator on the UniFi Security Gateway will turn blue to confirm that it is successfully adopted.
Optional WAN Port Configuration via Layer 3 By default, the WAN port is set to DHCP so it can be assigned network settings by the service provider. To change the setting, connect a computer directly (or through a switch) to the LAN port of the UniFi Security Gateway. 1. From a web browser, gohttps://setup.ubnt.com to https://setup.ubnt.com/ 2. The UniFi Gateway login window will appear. Enter your Username and Password. Click Sign In.
Specifications UniFi Security Gateway Dimensions 135 x 135 x 28.3 mm (5.32 x 5.32 x 1.11") Weight 366 g (12.9 oz) Networking Interfaces Serial Console Port Data Ports (1) RJ45 Serial Port (3) 10/100/1000 Ethernet Ports* Max.
Safety Notices 1. Read, follow, and keep these instructions. 2. Heed all warnings. 3. Only use attachments/accessories specified by the manufacturer. WARNING: Failure to provide proper ventilation may cause fire hazard. Keep at least 20 mm of clearance next to the ventilation holes for adequate airflow. WARNING: To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. WARNING: Do not use this product in location that can be submerged by water.
Limited Warranty UBIQUITI NETWORKS, Inc (“UBIQUITI NETWORKS”) warrants that the product(s) furnished hereunder (the “Product(s)”) shall be free from defects in material and workmanship for a period of one (1) year from the date of shipment by UBIQUITI NETWORKS under normal use and operation.
Disclaimer EXCEPT FOR ANY EXPRESS WARRANTIES PROVIDED HEREIN, UBIQUITI NETWORKS, ITS AFFILIATES, AND ITS AND THEIR THIRD PARTY DATA, SERVICE, SOFTWARE AND HARDWARE PROVIDERS HEREBY DISCLAIM AND MAKE NO OTHER REPRESENTATION OR WARRANTY OF ANY KIND, EXPRESS, IMPLIED OR STATUTORY, INCLUDING, BUT NOT LIMITED TO, REPRESENTATIONS, GUARANTEES, OR WARRANTIES OF MERCHANTABILITY, ACCURACY, QUALITY OF SERVICE OR RESULTS, AVAILABILITY, SATISFACTORY QUALITY, LACK OF VIRUSES, QUIET ENJOYMENT, FITNESS FOR A PARTICULAR PUR
Note Some countries, states and provinces do not allow exclusions of implied warranties or conditions, so the above exclusion may not apply to you. You may have other rights that vary from country to country, state to state, or province to province. Some countries, states and provinces do not allow the exclusion or limitation of liability for incidental or consequential damages, so the above limitation may not apply to you.
Australia and New Zealand Warning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. CE Marking CE marking on this product represents the product is in compliance with all directives that are applicable to it.
Español La Directiva 2012/19/UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
Declaration of Conformity Česky [Czech] UBIQUITI NETWORKS tímto prohlašuje, že toto UBIQUITI NETWORKS zařízení, je ve shod se základními požadavky a dalšími příslušnými ustanoveními směrnic 2014/30/EU, 2014/35/EU. Dansk [Danish] Hermed, UBIQUITI NETWORKS, erklærer at denne UBIQUITI NETWORKS enhed, er i overensstemmelse med de væsentlige krav og øvrige relevante krav i direktiver 2014/30/EU, 2014/35/EU.
UBIQUITI NETWORKS deklaruoja, kad šis UBIQUITI NETWORKS Lietuviškai [Lithuanian] įrenginys atitinka esminius reikalavimus ir kitas 2014/30/ES, 2014/35/ES Direktyvų nuostatas. Malti [Maltese] Hawnhekk, UBIQUITI NETWORKS, tiddikjara li dan il-mezz UBIQUITI NETWORKS huwa konformi mar-rekwiżiti essenzjali u dispożizzjonijiet rilevanti oħrajn ta ‘Direttivi 2014/30/UE, 2014/35/UE.
