Quick Start Guide

Hardware Overview
Ports Panel
Interface Description
Console
RJ45 serial console port for CLI management.
Use a RJ45-to-DB9 serial console cable to
connect the Console port to your computer.
Then configure using the following settings:
• Baud rate 115200
• Data bits 8
• Parity NONE
• Stop bits 1
• Flow control NONE
Reset
Resets to factory defaults. The UniFi Security
Gateway should be powered on. Press and hold
the Reset button for about 10seconds until
the right LED on the WAN 2 / LAN 2 port starts
flashing and then becomes solidly lit. After a
few seconds, the LED will turn off, and the UniFi
Security Gateway will automatically reboot.
WAN 1
Supports 10/100/1000 Ethernet WAN
connections. Default setting is DHCP client.
LAN 1
Supports 10/100/1000 Ethernet LAN
connections. Default setting is DHCP Server.
Server IP: 192.168.1.1/24
WAN 2 /
LAN 2
Supports 10/100/1000 Ethernet connections.
Configure the port using the UniFi Security
Gateway configuration interface.