User Guide

89
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 12: UniFi Access Point Details
• Min. RSSI (Not available for Zero Handoff.) Disabled
by default. Select this option and enter a minimum
threshold. For UniFi, RSSI is synonymous with SNR. If the
client signal falls below the specified threshold, then the
AP kicks out the client, allowing it to reconnect with a
more suitable AP.
Note: If the AP is part of a Zero Handoff WLAN
Group, the Min. RSSI setting cannot be changed.
Apply Click Apply to save your changes.
WLANs
You can deploy multiple wireless networks organized into
WLAN groups on different APs.
WLAN Group Select the appropriate group.
Name Displays the network name or SSID of the available
wireless network.
Overrides Displays the SSID override information applied
to the wireless network.
Actions Click a button to perform the desired action:
• Override Click Override to enable a VLAN (Virtual
Local Area Network), set the VLAN ID, and enter the SSID
override name to apply to the wireless network.
Note: The Override option is not available for a
Zero Handoff WLAN Group.
Override
Enabled Select the checkbox to enable the WLAN for use.
VLAN Select the checkbox to enable the VLAN.
• Use VLAN ID The VLAN ID is a unique value assigned
to each VLAN on a single device. Enter a value between
2 and 4095. For example, in a large deployment where
there are multiple buildings, you can use a different
VLAN ID for each building while all of the VLANs remain
on the same corporate network.
SSID Enter the SSID override name to apply to the
wireless network.
PSK If the WPA-Personal security option has been
applied to the WLAN under Settings > Wireless Networks,
then the Pre-Shared Key (PSK) for the SSID specified will
automatically appear in this field.
Actions Click a button to perform the desired action:
• Apply Click Apply to save changes.
• Restore Click Restore to remove any overrides that
were applied to the selected wireless network.
• Cancel Click Cancel to discard changes.