User Guide
87
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 12: UniFi Access Point Details
2G/5G Select the frequency band you want to analyze.
RF Scan Click
RF SCAN
to scan the RF environment and
then click Confirm to continue.
Note: The RF scan may take more than five minutes.
All clients using this AP will be disconnected, and
the AP will be offline for the duration of the scan.
Each bar graph represent a channel option and its
color-coded level of interference (from green at -96 dBm
to red at -32dBm).
__ MHz The 2.4 GHz results are displayed in channel
widths of 20 and 40 MHz. The 5 GHz results are displayed
in channel widths of 20, 40, and 80 MHz.
__ Displays the corresponding channel number for each
channel width option.
(outlined) The current channel is outlined.
Place your cursor over a channel option to view the
following:
• Channel _ Displays the channel number and frequency
range.
• Utilization Displays the percentage of the frequency
range already in use.
• Interference Displays the level of interference.
• Interference Types Displays the type of interference
being detected.
Scanned Displays the duration of time since the last scan.
UniFi Access Point – Users
Name Displays the hostname, alias, or MAC address of the
connected client. You can click the name to get additional
details; see “Client Details” on page 97 for more
information.
WLAN Displays the name or SSID of the wireless network
in use.
Signal Displays the percentage of signal strength
between the user and AP.
TX Displays the transmit rate.