User Guide

63
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 9: Insights
You can place your mouse over the Activity icon to display
the specific TX or RX rate.
Actions Click a button to perform the desired action:
• Edit Click
to make changes to the port settings.
For more information, see “UniFi Switch Details” on
page 75.
• Power Cycle If applicable, click
to power
cycle the port.
PoE
You can apply the PoE Mode filter:
• All Displays all ports using any PoE Mode setting.
• Enabled Displays all ports set to PoE+ or 24V Passive.
• Power On Displays all ports with PoE detected.
• Passive Displays all ports set to 24V passive PoE.
• Disabled Displays all ports with PoE disabled.
The ports display their status:
Indicates a 10/100 Mbps connection.
Indicates 10/100 Mbps connection with PoE.
Indicates a 1000 Mbps connection.
Indicates 1000 Mbps connection with PoE.
Indicates the conection is disabled (no network
or VLAN is enabled).
Indicates no connection (the network or VLAN is
enabled, but the port is not in use).
Switch If Switch: All is selected, then this displays the
hostname, alias, or MAC address of the UniFi Switch. You
can click the name to get additional details. For more
information, see “UniFi Switch Details” on page 75.
Port Displays the port number.
Name Displays the name of the port.
PoE Mode Displays the PoE setting:
• Disabled PoE is disabled.
• 24V Passive 24V passive PoE is enabled.
• PoE+ 802.3at/af devices can be plugged in and
automatically receive PoE.
PoE Detection Displays the PoE status:
• Not detected No 802.3at/af device is detected.
• Passive 24V passive PoE is enabled.
• Good An 802.3at/af device is plugged in and
automatically receiving PoE.
PD Class Displays the PD (Powered Device) class of the
detected device, if applicable; this indicates its power
requirements.
Power Displays the power output in watts, if applicable.
Voltage Displays the voltage output, if applicable.
Current Displays the current output in amperes, if
applicable.
Actions Click a button to perform the desired action:
• Edit Click
to make changes to the port settings.
For more information, see “UniFi Switch Details” on
page 75.
• Power Cycle If applicable, click to power
cycle the port.
Counters
Clear counters Select one of the following:
• All Resets all counters to zero.
• (switch_name) Resets the counters of the selected
UniFi Switch to zero.
Switch If Switch: All is selected, then this displays the
hostname, alias, or MAC address of the UniFi Switch. You
can click the name to get additional details. For more
information, see “UniFi Switch Details” on page 75.
Port Displays the port number.
TX Bytes Displays the number of bytes transmitted.
TX Frames Displays the number of frames transmitted.
TX Multicast Displays the number of multicast packets
transmitted.