User Guide

62
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 9: Insights
Package Displays the name of the guest access package.
Amount Displays the amount paid by the guest.
Authorized By Displays the name of the authorizing
body.
Start Displays the start date and time of the session.
Duration Displays the length of time the guest was
connected.
Down Displays the total amount of data downloaded by
the guest.
Up Displays the total amount of data uploaded by
theguest.
IP Displays the last known IP address of the guest.
Last AP/Port Displays the name or MAC address of the
last AP used by the wireless guest or the last port used by
the wired guest. You can click the device name for more
information; refer to “UniFi Access Point Details” on
page 83 or “UniFi Switch Details” on page 75 .
Switch Stats
You can apply one of the following primary filters:
• Switch Displays the ports of all UniFi Switches or a
specific Switch.
• Link Status Displays the ports of the specified status:
- All Displays all ports.
- Connected Displays all connected ports.
- Disconnected Displays all disconnected ports.
Once you have applied the primary filters, then apply a
secondary filter:
• Overview Displays the general status information of
each port.
• PoE Displays the specific PoE configuration and status
of each port.
• Counters Displays the specific TX and RX rates for
eachport.
Overview
The ports display their status:
Indicates a 10/100 Mbps connection.
Indicates 10/100 Mbps connection with PoE.
Indicates a 1000 Mbps connection.
Indicates 1000 Mbps connection with PoE.
Indicates the conection is disabled (no network
or VLAN is enabled).
Indicates no connection (the network or VLAN is
enabled, but the port is not in use).
Switch If Switch: All is selected, then this displays the
hostname, alias, or MAC address of the UniFi Switch. You
can click the name to get additional details. For more
information, see “UniFi Switch Details” on page 75.
Port Displays the port number.
Name Displays the name of the port.
PoE Displays the PoE setting:
• Disabled PoE is disabled.
• 24V Passive 24V passive PoE is enabled.
• PoE+ 802.3at/af devices can be plugged in and
automatically receive PoE.
Mode Displays the operation mode:
• Switching The default mode.
• Mirroring The network traffic of this port will receive
the mirrored traffic from the port selected in ”Port
Configuration” on page 77.
• Aggregate This port is part of an aggregate link. A port
channel, also known as a Link Aggregation Group (LAG),
combines multiple links into a single logical link (single
IP address) for load balancing and/or redundancy.
Networks/VLANs Displays the networks/VLANs that the
port belongs to.
Link Status Displays the connection speed and duplex
mode.
STP Displays the STP (Spanning Tree Protocol) mode.
TX Displays the amount of data transmitted.
RX Displays the amount of data received.
TX Rate Displays the transmit rate.
RX Rate Displays the receive rate.
Activity Displays the level of activity. The different colors
represent different types of packet activity.
Color Packet Activity
TX rate
RX rate