User Guide

48
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 6: Devices
Phones
VoIP is available with UniFi Controller version 4.6 or higher.
Upgrade All Click to begin automatically
upgrading the firmware of all Phones.
(icon) Displays the icon corresponding to the Phone (not
all icons are shown below):
UniFi VoIP Phone/Pro
UniFi VoIP Phone Executive
Name/MAC Address Displays the hostname, alias, or
MAC address of the Phone. You can click the name to get
additional details; see “UniFi VoIP Phone Details” on
page 95 for more information.
IP Address Displays the IP address used by the Phone.
Status Indicates the device status: Connected,
Disconnected, Pending Approval, Adopting, Upgrading, or
Managed by Other.
Only the super admin – not any site admin – can view
devices that are Pending Approval and then adopt them on
the UniFi Controller.
Note: The super admin account was created during
the initial installation; for more information, see
“Configuring the UniFi Controller Software” on
page 2.
Model Displays the model name of the UniFi device.
Extension Displays the extension of the Phone. You
can click the extension to get additional details; see
“UniFi VoIP Phone – Details” on page 95 for more
information.
Actions Click a button to perform the desired action:
• Locate Click to ring the Phone and flash the
Phone’s icon on the Map tab so you can locate it. The
Phone will ring until you click Locate again. (The icon on
the Map tab will flash three times and stop.)
• Restart Click to restart the selected device.
• Upgrade If a software upgrade is available for the
device, click to install the latest UniFi firmware
on the device. The Status will appear as Upgrading until
the process is complete and the device reconnects to
the UniFi Controller software.
• Adopt Click to adopt a device that appears as
Pending Approval for its status. The Status will appear as
Adopting until the device is connected.
Properties
The Properties tab is hidden by default. To display it, click
the properties icon. The Properties tab appears on the
right side of the Devices screen.
Information about each selected device appears as a
popup within this tab. The information varies depending
on the device type.
For more information, see the appropriate chapter:
• “UniFi Security Gateway Details” on page 67
• “UniFi Switch Details” on page 75
• “UniFi Access Point Details” on page 83
• “UniFi VoIP Phone Details” on page 95
Close Click to close the Properties tab and device
popups.