User Guide

30
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 3: Using the UniFi Controller Software
- SIP Voicemail Enter the URL or IP address of the SIP
voicemail server.
• Save Click
to apply changes.
• Cancel Click
CANCEL
to discard changes.
Settings > Controller
Configure the system settings of the UniFi Controller.
Controller Settings
Controller Hostname/IP Enter the hostname or IP
address of the UniFi Controller.
Note: When alert emails are sent out, the Controller
Hostname/IP will be specified in the Controller URL at
the bottom of every message.
• Override inform host with Controller
Hostname/IP An inform host URL is used for layer-3
device adoption using the UniFi Discovery Utility. Select
this option to override the inform host URL. Then enter
the appropriate hostname or IP address.
Note: The default inform port is 8080. (You can
customize this in system.properties.)
Network Discovery When enabled, this option allows
UniFi to be discoverable via UPnP. This option is disabled
by default.
Update Image Cache Disabled by default. Select this
option to enable the automatic update of the cached VoIP
phone image.
Mail Server
When enabled, UniFi will send email alerts triggered by
disconnected UniFi devices. Specify the administrator
email address when you create an account under
“Settings > Admins” on page 27.
SMTP Server Select this option to enable emails.
• Enable mail server Enter the outgoing (SMTP) mail
server name.
• Port The default is 25. If Secure Sockets Layer (SSL)
is enabled, then the port number will automatically
change to 465.
• Enable SSL You can enable SSL to enhance secure
communications over the Internet.
• Enable authentication Select this option to enable
authentication.
- Username Enter the username required by the
mailserver.
- Password Enter the password required by the
mailserver.
• Specify sender address Select this option to specify
the sender email address. Enter the email address that
will appear as the sender of the email alert.
• Test SMTP Server Enter an email address and click
Send to test the mail server setup.
Apply Click to save changes.
Settings > Cloud Access
Set up the login for cloud access.
Enable Cloud Access Click to configure the
login. The Cloud Login Credentials screen will appear.
Cloud Login Credentials
• Email or Username Enter the email address or
username of your UBNT account.
• Password Enter the password of your UBNT account.
• Click here if you do not have an account If you do not
have a UBNT account, click here to visit this link:
https://account.ubnt.com/register
Follow the on-screen instructions to set up a UBNT
account.
• Enable Cloud Access Click to save
changes.
• Cancel Click
CANCEL
to discard changes.