User Manual

89
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 10: UniFi Security Gateway Details
Queue Changes Click Queue Changes to line up the
changes to take effect. This allows you to make multiple
changes to the device and then apply them all at once
so that the device doesn’t have to re-provision over and
over again when you change different sections of the
configuration. Each section with pending changes is
highlighted by an ellipsis.
When you are done with your changes, click Apply
Changes at the bottom of the screen. (You can cancel the
changes of any section by clicking X of the appropriate
section.)
Cancel Click Cancel to discard changes.
Pending Changes If you want queue changes for
multiple devices and then apply them later, the Pending
Changes option appears in the Properties panel. Click
to display the devices.
Apply Click
APPLY
to save changes.
Discard Click
DISCARD
to cancel changes.
Port Forward
Create Click
CREATE
to add a new entry. Go to “Create or
Edit Port Forwarding Entry” on page 90.
Name Displays the name of the port forwarding entry.
From Displays the source IP address, if specified.
Port Displays the port or ports that will be forwarded to
the LAN. Also known as the external port(s).
Dest IP/Port Displays the destination IP address and
port(s) that will receive the forwarded port traffic. Also
known as the internal port(s).
Actions Click a button to perform the desired action:
• Edit Click to edit the port forwarding entry.
• Delete Click to delete the port forwarding entry.