User Manual

107
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 12: UniFi Access Point Details
Note: The RF scan may take more than five minutes.
All clients using this AP will be disconnected, and
the AP will be offline for the duration of the scan.
Each bar graph represent a channel option and its
color-coded level of interference (from green at -96 dBm
to red at -32dBm).
__ MHz The 2.4 GHz results are displayed in channel
widths of 20 and 40 MHz. The 5 GHz results are displayed
in channel widths of 20, 40, and 80 MHz.
__ Displays the corresponding channel number for each
channel width option.
(outlined) The current channel is outlined.
Place your cursor over a channel option to view the
following:
Overview
• Radio Displays the radio being used.
• Channel Width Displays the width of the channel.
• Frequency Range Displays the range of frequencies.
RF Scan Details
• Utilization Displays the percentage of the frequency
range already in use.
• Interference Displays the level of interference.
• Interference Types Displays the type of interference
being detected.
Last scan Displays the duration of time since the last
scan.
UniFi Access Point – Users
(sort) You can click any column to sort the displayed list.
The selected column displays or to indicate ascending
or descending order.
Name Displays the hostname, alias, or MAC address of
the connected client and the name or SSID of the wireless
network in use. You can click the name to get additional
details; see “Client Details” on page 117 for more
information.
Signal Displays the signal strength between the user
andAP.
TX Rate Displays the transmit rate.