User Manual

3
Chapter 1: Software InstallationUniFi Controller User Guide
Ubiquiti Networks, Inc.
Note: If there is more than one page of entries
to display, click the navigation controls or page
numbers at the bottom right of the screen to display
different pages.
4. The UniFi Setup Wizard will create a secure primary
wireless network for your devices.
Perform the following steps:
a. Enter the wireless network name (SSID) in the Secure
SSID field.
b. Enter a passphrase to be used for your primary
network in the Security Key field.
c. To enable guest access, select Enable Guest Access,
and enter a guest network name in the Guest
SSIDfield.
d. Click Next.
5. Create the super admin for your UniFi Controller.
Perform the following steps:
a. Enter an admin name in the Admin Name field.
b. Enter an email address in the Admin Email field.
c. Enter a password in the Password field to use when
accessing the management interface as a super
admin.
d. Confirm your password in the Confirm Password
field.
e. Click Next.
Note: Only the super admin –not any site admin–
can view wired devices that are Pending Approval
and then adopt them on the UniFi Controller. Ensure
that you save the super admin login information for
futureuse.
6. Enter your Ubiquiti account email/username and
password to enable to Cloud Access. Alternatively, you
can click register now, to create a Ubiquiti account.
Click Next.
7. Review your settings. Click Finish to save your settings
or click Back to make changes. Once the wizard
is finished, the browser will be redirected to the
management interface.
Congratulations, your wireless network is now configured.
A login screen will appear for the UniFi Controller
management interface. Enter the admin name and
password that you created and click Login.