User Manual

ManualsBrandsUbiquiti Networks ManualsNetworkingUS-24-250W

UniFi Controller User Guide

Ubiquiti Networks, Inc.

Chapter 6: Devices

Actions Click a button to perform the desired action:

• Locate Click

to flash the LED on the AP and the

AP’s icon on the Map tab so you can locate it. The LED

will flash until the Locate button is clicked again. (The

icon on the Map tab will flash three times and stop.)

• Restart Click

to restart the selected device.

• Upgrade If a software upgrade is available for the

device, click

to install the latest UniFi firmware

on the device. The Status will appear as Upgrading until

the process is complete and the device reconnects to

the UniFi Controller software.

• Adopt Click

to adopt a device that appears as

Pending Approval for its status. The Status will appear as

Adopting until the device is connected.

Phones

Important: For management of the UniFi VoIP

Phones, please download the UniFi VoIP Controller

here: downloads.ubnt.com/unifi

(icon) Displays the icon corresponding to the Phone (not

all icons are shown below):

UniFi VoIP Phone/Pro

UniFi VoIP Phone Executive

Device Name Displays the hostname, alias, or MAC

address of the Phone. You can click the name to get

additional details; see “UniFi VoIP Phone Details” on

page 115 for more information.

IP Address Displays the IP address used by the Phone.

Status Indicates the device status: Connected,

Disconnected, Pending Approval, Adopting, Upgrading, or

Managed by Other.

Only the super admin – not any site admin – can view

devices that are Pending Approval and then adopt them on

the UniFi Controller.

Note: The super admin account was created during

the initial installation; for more information, see

“Configuring the UniFi Controller Software” on

page 2.

Model Displays the model name of the Phone.

Version Displays the version number of the Phone’s

firmware.

Uptime Displays the duration of time the Phone has been

running.