User Manual

60
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 6: Devices
The very first time you enable the Customize Columns
option, the UniFi Controller software will detect which
columns are currently visible and remember your
selection. For example:
1. Enable the Customize Columns option on the APs >
Performance screen.
2. Disable customization.
3. Apply the Gateway/Switches filter.
4. Enable the Customize Columns option again.
5. The columns of the APs > Performance screen will be
displayed.
Click to customize the columns used for display.
Select Customize columns.
You can select additional columns for display.
• Reset columns to Click the drop-down at the bottom
of the Customize columns screen to display the Reset
columns to ... options. The option you select will apply
no matter which primary filter: All, Gateway/Switches,
APs, or Phones you select. This resets the columns but
the UniFi Controller software will not remember your
selection.
- Default The Device Name, IP Address, Status, Model,
Version, Uptime, and Actions columns are displayed.
- Gateway/Switches The Device Name, IP Address,
Status, Model, Down, Up, and Actions columns are
displayed.
- AP Overview The Device Name, IP Address, Status,
Model, Clients, Down, Up, Channel and Actions columns
are displayed.
- AP Performance The Device Name, IP Address, Status,
2G Clients, 5G Clients, TX, RX, TX 2G, TX 5G, Channel, and
Actions columns are displayed.
- AP Config The Device Name, Status, Version, WLAN2G,
WLAN5G, Radio2G, Radio5G and Actions columns are
displayed.
- All columns The Device Name, MAC Address, IP
Address, Status, Model, Version, Uptime, Clients, Down,
Up, WLAN2G, WLAN5G, Radio2G, Radio5G, 2G Clients,
5G Clients, TX, RX, TX 2G, TX 5G, Channel, Ch. Util. 2G,
Ch. Util. 5G, and Actions columns are displayed.
Enable Group Config Use this feature to configure an
entire group of UniFi APs at the same time. The following
AP settings can be changed with batch configuration:
• Radio Channel
• Radio Channel Width
• Radio Transmit Power
• Minimum RSSI
• WLAN Groups
• Band Steering
• Airtime Fairness
• Disable Device
• Enable/disable LED
To configure a group of APs, click and then select
Enable group config.
For detailed instructions and information on AP group
configuration, refer to the following online help article:
ubnt.link/UniFi-AP-Group-Configuration