User Manual

126
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Appendix A: Portal Customization with LegacyJSP
Viewing the Default Portal
Once Guest Portal and Override Default Templates are
enabled, connect to the Guest Network SSID as shown
below, depending on your platform.
Windows
1. Go to Connect to Network.
• Windows 8 Go to the Settings menu and click the
Network icon.
• Windows 10/7 Right-click the Network icon.
2. Select the Guest Network SSID and click Connect.
3. Depending on the security type applied to the
network, enter the security key or password. Click OK
or Connect.
4. Launch your web browser and you will be directed to
the default portal page for the authentication type
configured on the Guest Portal (see “Settings > Guest
Control” on page 32 for screenshots of default
portal pages by authentication method).
Mac
1. Click the AirPort icon in the menu bar (top right
side of the screen).
2. Select the Guest Network SSID and click Connect.
3. Depending on the security type applied to the
network, enter the security key or password. Click OK.
4. Once connected, the AirPort icon will change from
gray to solid black. The number of black lines indicates
the signal strength.
5. Launch your web browser and you will be directed to
the default portal page for the authentication type
configured on the Guest Portal (see “Settings > Guest
Control” on page 32 for screenshots of default
portal pages by authentication method).
Setup
The html and css files are located on the system that the
UniFi Controller software has been installed on. The files
are in the following locations:
UniFi Cloud Key
/srv/unifi/data/sites/<site_name>/portal
Mac
/Applications/UniFi.app/Contents/Resources/data/
sites/<site_name>/portal
Windows
<Drive_Letter>:\Users\<Username>\Ubiquiti UniFi\data\
sites\<site_name>\portal
For specific instructions on accessing the files, refer to the
specific operating system:
• Mac
• “Windows” on page 128
Mac
1. Navigate to Go > Applications.
2. Control-click the UniFi application and then click Show
Package Contents.
3. Double-click the Contents folder to open it.
4. Double-click the Resources folder to open it.