User Manual

110
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 12: UniFi Access Point Details
Override
Enabled on this AP Select the checkbox to enable the
WLAN for use.
Use VLAN Select the checkbox to enable the VLAN.
• with VLAN ID The VLAN ID is a unique value assigned
to each VLAN on a single device. Enter a value between
2 and 4095. For example, in a large deployment where
there are multiple buildings, you can use a different
VLAN ID for each building while all of the VLANs remain
on the same corporate network.
SSID Enter the SSID override name to apply to the
wireless network.
Security Key If the WPA-Personal security option has
been applied to the WLAN under Settings > Wireless
Networks, then the Pre-Shared Key (PSK) for the SSID
specified will automatically appear in this field.
Actions Click a button to perform the desired action:
• Save Click Save to apply changes.
• Reset to Defaults Click Reset to Defaults to remove
any overrides that were applied to the selected wireless
network.
• Cancel Click Cancel to discard changes.
Network
Configure IP Select the Internet connection type for
your service, Using DHCP or Static IP. Proceed to the
appropriate instructions.
Using DHCP
• Using DHCP The use of the Dynamic Host
Configuration Protocol (DHCP) is the default. The AP
automatically acquires network settings from the
network’s DHCP server.
• Queue Changes Click Queue Changes to line up the
changes to take effect. This allows you to make multiple
changes to the device and then apply them all at once
so that the device doesn’t have to re-provision over and
over again when you change different sections of the
configuration. Each section with pending changes is
highlighted by an ellipsis.
When you are done with your changes, click Apply
Changes at the bottom of the screen. (You can
cancel the changes of any section by clicking X of the
appropriate section.)
• Cancel Click Cancel to discard changes.
• Pending Changes If you want queue changes for
multiple devices and then apply them later, the Pending
Changes option appears in the Properties panel. Click
to display the devices.
- Apply Click
APPLY
to save changes.
- Discard Click
DISCARD
to cancel changes.
Static IP
• Static IP Assign fixed network settings to the AP. Enter
the following information:
- IP Address Enter the IP address for the AP.
- Subnet Mask Enter the subnet mask of the AP.
- Gateway Enter the IP address of the gateway (for
example, the UniFi Security Gateway).
- Preferred DNS Enter the IP address of the primary
DNS server.
- Alternate DNS Enter the IP address of the secondary
DNS server.
- DNS Suffix Enter the Fully Qualified Domain Name
(FQDN) without the hostname.
• Queue Changes Click Queue Changes to save
changes.
• Cancel Click Cancel to discard changes.
• Static IP Assign fixed network settings to the AP. Enter
the following information:
- IP Address Enter the IP address for the AP.
- Subnet Mask Enter the subnet mask of the AP.
- Gateway Enter the IP address of the gateway (for
example, the UniFi Security Gateway).