User Manual

109
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 12: UniFi Access Point Details
Queue Changes Click Queue Changes to line up the
changes to take effect. This allows you to make multiple
changes to the device and then apply them all at once
so that the device doesn’t have to re-provision over and
over again when you change different sections of the
configuration. Each section with pending changes is
highlighted by an ellipsis.
When you are done with your changes, click Apply
Changes at the bottom of the screen. (You can cancel the
changes of any section by clicking X of the appropriate
section.)
Cancel Click Cancel to discard changes.
Pending Changes If you want queue changes for
multiple devices and then apply them later, the Pending
Changes option appears in the Properties panel. Click
to display the devices.
• Apply Click
APPLY
to save changes.
• Discard Click
DISCARD
to cancel changes.
WLANs
You can deploy multiple wireless networks organized into
WLAN groups on different APs.
WLAN Group Select the appropriate group.
Name Displays the network name or SSID of the available
wireless network.
Overrides Displays the SSID override information applied
to the wireless network.
Actions Click a button to perform the desired action:
• Edit Click to enable a VLAN (Virtual Local Area
Network), set the VLAN ID, and enter the SSID override
name to apply to the wireless network.
Note: The Override option is not available for a
Zero Handoff WLAN Group.
Queue Changes Click Queue Changes to save changes.
Cancel Click Cancel to discard changes.