User Manual

103
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 12: UniFi Access Point Details
Chapter 12: UniFi Access Point
Details
A UniFi AP hyperlink opens the UniFi AP’s Details window
either in the Properties panel or as a separate popup
window. You can always dock this window in the Properties
panel or detach it as a separate window.
Properties
The Properties panel appears on the right side of the
screen. Information about each selected device appears as
a popup within this panel.
Remove All Click to close the Properties panel.
Collapse All Click to collapse all of the popups
torows.
The top of the popup remains and displays the following:
• Display Click to display the device information.
• (icon) Displays the icon of the device (the icon will vary
depending on the model).
• (status) Displays to indicate the device status.
- Pending Approval A solid orange circle indicates
the default state, available for adoption.
- Connected A solid green circle indicates a
managed connection.
- Managed by Other A solid gray circle indicates
that the device is not in the default state but not
controlled by the current UniFi Controller.
- Disconnected or Isolated A red warning icon
!
indicates no connection. To establish a connection
to the UniFi Controller, perform one of the following
actions:
• Reconnect the AP to the gateway or router.
• Connect an Ethernet cable from the Secondary
Ethernet Port (if available) of the isolated AP to the
Secondary Ethernet Port (if available) of another UniFi
AP that is connected to the gateway or router.
• Establish a wireless uplink to a wired AP.
• Name/MAC Address Displays the device name or MAC
address of the device.
• Restart Click to restart the selected device.
• Locate Click to flash the LED on the device and the
device icon on the Map tab so you can locate it. The LED
will flash until the Locate button is clicked again. (The
icon on the Map tab will flash three times and stop.)
• Upgrade Click to upgrade the device. (This icon
does not appear if an upgrade is not available or there
are pending changes.)
• Undock from Properties Panel Click to display the
same information in a separate popup screen that can
be moved anywhere within the browser screen.
• Close Properties Click to close the device popup.
Hide Property Panel Click to hide the Properties panel
but allow the device popups to remain accessible from
this panel. Click the properties icon to re-open it.
There are four clickable tabs:
• “UniFi Access Point – Details” on page 104
• “UniFi Access Point – Users” on page 107
• “UniFi Access Point – Guests” on page 108
• ”UniFi Access Point – Configuration” on page 108