User Manual

100
UniFi Controller User Guide
Ubiquiti Networks, Inc.
Chapter 11: UniFi Switch Details
• Enable RADIUS VLAN Allows the RADIUS server to
dynamically assign a VLAN to a wired client.
• RADIUS Auth Server Provide the following information
about the RADIUS authentication server:
- IP Address Enter the IP address.
- Port Enter the port number. The default is 1812.
- Password Enter the password.
- Delete Click the delete icon to remove this
accounting server.
- Add Auth Server If you have another authentication
server, click this option and complete the IP Address,
Port, and Password fields.
• RADIUS Accounting Server Provide the following
information about the RADIUS server:
- IP Address Enter the IP address.
- Port Enter the port number. The default is 1813.
- Password Enter the password.
- Delete Click the delete icon to remove this
accounting server.
- Add Accounting Server If you have another
accounting server, click this option and complete the
IP Address, Port, and Password fields.
Queue Changes Click Queue Changes to line up the
changes to take effect. This allows you to make multiple
changes to the device and then apply them all at once
so that the device doesn’t have to re-provision over and
over again when you change different sections of the
configuration. Each section with pending changes is
highlighted by an ellipsis.
When you are done with your changes, click Apply
Changes at the bottom of the screen. (You can cancel the
changes of any section by clicking X of the appropriate
section.)
Cancel Click Cancel to discard changes.
Pending Changes If you want queue changes for
multiple devices and then apply them later, the Pending
Changes option appears in the Properties panel. Click
to display the devices.
• Apply Click
APPLY
to save changes.
• Discard Click
DISCARD
to cancel changes.