User Manual
Table Of Contents
- Introduction
- Hardware Overview
- Hardware Installation
- Powering the Cloud Key Gen2 Plus
- Optional Rackmount Accessory
- Setting Up UniFi SDN via App
- Pre-installed Software
- Setting Up UniFi Protect via App
- Chrome Instructions
- Setting Up UniFi SDN
- Setting Up UniFi Protect
- Cloud Key G2+ Settings
- HDD Replacement
- Specifications
- Safety Notices
- Electrical Safety Information
- Limited Warranty
- Compliance
- Declaration of Conformity
22
4. Once connected, the first of two Device setup screens will
appear. Enter a Device name for the UniFi Protect controller
and tap Next.
5. When the second Device setup screen appears, select the
services you wish to enable by tapping the toggle switch
to on, for each of the following items: Enable Cloud Access
(which is currently enabled by default and cannot be
disabled at this time), Allow Local Login with SSO, and
Enable UniFi SDN. When you are finished, tap Next.