User Manual
Table Of Contents
- Introduction
- Hardware Overview
- Hardware Installation
- Powering the Cloud Key Gen2 Plus
- Optional Rackmount Accessory
- Setting Up UniFi SDN via App
- Pre-installed Software
- Setting Up UniFi Protect via App
- Chrome Instructions
- Setting Up UniFi SDN
- Setting Up UniFi Protect
- Cloud Key G2+ Settings
- HDD Replacement
- Specifications
- Safety Notices
- Electrical Safety Information
- Limited Warranty
- Compliance
- Declaration of Conformity
21
2. When the Controllers screen appears, it will list any existing
managed UniFi Protect controllers, as well as the status of
the cloud services and version information for each. To add
a new controller, tap Add Controller.
Note: If your app was previously connected to a
controller, it will automatically connect to that
controller.
3. When the Cloud Key Gen2 Plus is discovered, tap
Set up this device and wait for it to connect.