User Manual
Table Of Contents
- Introduction
- Hardware Overview
- Hardware Installation
- Powering the Cloud Key Gen2 Plus
- Optional Rackmount Accessory
- Setting Up UniFi SDN via App
- Pre-installed Software
- Setting Up UniFi Protect via App
- Chrome Instructions
- Setting Up UniFi SDN
- Setting Up UniFi Protect
- Cloud Key G2+ Settings
- HDD Replacement
- Specifications
- Safety Notices
- Electrical Safety Information
- Limited Warranty
- Compliance
- Declaration of Conformity
13
When connecting the Cloud Key Gen2 Plus to the Rackmount
Accessory, the width of the Docking Bay must be adjusted to
accommodate the dimensions. To adjust the Docking Bay:
1. Press down on the Lock Tab and slide the docking bay
cover open until it locks into place.
2.
Remove the pre-installed sticker from the 13-pin connector.
3. Insert the Cloud Key Gen2 Plus into the docking bay once
the following three conditions are met:
a. The 13-pin connector is face up
b. The LCD screen is face forward
c. There is no Ethernet cable connected to the
Ethernet Port on the Cloud Key Gen2 Plus
Warning:
To prevent creating a loop or other
unfavorable behavior on the network, only one
Ethernet connection should be used. Do not use the
Ethernet port on the Cloud Key Gen2 Plus and
the Rackmount Accessory simultaneously.