Quick Start Guide
Table Of Contents
- Introduction
- Hardware Overview
- Hardware Installation
- Powering the Cloud Key Gen2 Plus
- Optional Rackmount Accessory
- Setting Up UniFi SDN via App
- Pre-installed Software
- Setting Up UniFi Protect via App
- Chrome Instructions
- Setting Up UniFi SDN
- Setting Up UniFi Protect
- Cloud Key G2+ Settings
- HDD Replacement
- Specifications
- Safety Notices
- Electrical Safety Information
- Limited Warranty
- Compliance
- Declaration of Conformity
5
Hardware Overview
Front Panel LED
LED
Color State Status
White Solid Device is ready to be configured
Flashing Device is booting up
Device is initializing/deinitializing
Heartbeat Firmware update in process
Blue Solid Device is configured and ready
Flashing Main power has been lost and
device is counting down.
If power is restored within 10
seconds, the device will return to
its previous state. If power is not
restored within 10 seconds, the
device will safely shutdown.
Slow
Flashing
Client connected to device via
Bluetooth (BLE)
Off/White/
Blue
Flashing Device is in recovery mode.
The LED will cycle through a
pattern at one-second intervals,
between off, white, and blue.