Quick Start Guide
Table Of Contents
- Introduction
- Hardware Overview
- Hardware Installation
- Powering the Cloud Key Gen2 Plus
- Optional Rackmount Accessory
- Setting Up UniFi SDN via App
- Pre-installed Software
- Setting Up UniFi Protect via App
- Chrome Instructions
- Setting Up UniFi SDN
- Setting Up UniFi Protect
- Cloud Key G2+ Settings
- HDD Replacement
- Specifications
- Safety Notices
- Electrical Safety Information
- Limited Warranty
- Compliance
- Declaration of Conformity
12
Optional Rackmount Accessory
There is an optional UniFi Rackmount Accessory (sold
separately) that can mount the Cloud Key Gen2 Plus in a
standard 19" rack.
Lock Tab
Docking
Bay
To install the Rackmount Accessory, follow these instructions:
1. Attach the Rackmount Accessory to the rack using four
Mounting Screws. (If the rack has square slots, then use
Cage Nuts with the Mounting Screws.)
2. Connect an Ethernet cable (not included) to the Ethernet
Port on the front of the Rackmount Accessory.
3. Connect the other end of the Ethernet cable to a port on a
compatible PoE switch, such as a UniFiPoE Switch.