User's Manual

Chapter 2: InstallationUniFi

™

AP-Mini User Guide

Ubiquiti Networks, Inc.

7. Turn the AP clockwise until it locks into place.

8. Rotate the center logo to the desired position.

Ceiling-Mount

1. Remove the ceiling tile.

2. Position the Mounting Bracket in the center of the

ceiling tile.

3. Use a pencil to mark the three holes on the ceiling tile.

4. Use a 3.5 mm drill bit to drill holes for the flathead

screws.

5. Cut or drill a circle approximately 25 mm in size that

lines up with the large hole of the Mounting Bracket.

This will be used to feed the Ethernet cable through

the tile.

6. Secure the Mounting Bracket to the ceiling tile by

feeding the three flathead screws through the ceiling

tile. Support the Mounting Bracket with the washers

and Keps nuts on the top side of the ceiling tile.

7. Feed the Ethernet cable through the hole in the

Mounting Bracket and ceiling tile.