User's Manual

3
Chapter 2: InstallationUniFi
™
AP-Mini User Guide
Ubiquiti Networks, Inc.
Chapter 2: Installation
Hardware Installation
The UniFi AP-Mini is powered by the included PoE (Power
over Ethernet) adapter. To install the AP, perform the
following steps:
1. Connect an Ethernet cable to the Ethernet port on the
UniFi AP-Mini.
2. Connect the other end of the Ethernet cable to the
Ethernet port on the PoE Adapter.
Note: If you plan to mount the AP on the ceiling,
perform the ceiling mount installation steps before
connecting the Ethernet cable to the PoE Adapter.
3. Connect the PoE Adapter to your router or switch and
connect the power adapter to a power outlet.
Mounting the Access Point
The UniFi AP-Mini can be wall mounted or mounted on
a ceiling. Perform the following steps for the appropriate
installation:
Wall-Mount
1. Position the Mounting Bracket at the desired location
on the wall. Orient the mounting plate with the arrow
facing up.
2. Use a pencil to mark the three holes on the wall.
3. Use a 6 mm drill bit to drill the holes in the wall.
4. Insert the three screw anchors into the wall.
5. Secure the Mounting Bracket to the wall by inserting
the self tapping screws into the anchors.
6. Align the two notches on the AP with the notches on
the Mounting Bracket.