User's Manual

28
Chapter 10: Access Point DetailsUniFi
™
AP-Mini User Guide
Ubiquiti Networks, Inc.
Guests
Name Displays the name (MAC address if not defined)
of users connected to the guest network of the selected
Access Point. You can click the links under Name to display
additional details of each user (see “User/Guest Details”
on page 34 for more information).
WLAN Displays the name of the SSID (network name) of
the wireless LAN (WLAN) that the user is connected to.
Actions Select from one of the following actions:
•
Block Click this button to block a specific user from
accessing the Access Point. This will add the client to the
Blocked Device list.
• Reconnect Click this button to reconnect a specific user
to the Access Point.
Configuration
Allows you to change device configuration settings. Click
the Apply button to commit any changes.
Config
General Settings
Alias Allows you to name the device.
Radio (11n/b/g)
Channel Select a channel or leave the default auto
setting. You can also use the default HT20 for 20 MHz
operation or HT40 for 40 MHz operation.
Tx Power By default the transmit power is set to Auto. You
can also manually select High, Medium, Low or Custom.
•
High The highest TX power we can deliver.
•
Low The lowest TX power.
•
Medium Halfway in between High and Low.
•
Custom Full custom setting. If the AP is using an
external antenna, the Antenna Gain field will appear,
allowing you to specify the gain of the attached
antenna. After applying the settings, go to Transmit
Power under Detail > Radio (11/n/g/b), which always
shows EIRP, and place the mouse over it to display how
it’s calculated.