User's Manual

Warranty Conditions

The foregoing warranty shall apply only if:

(I) The Product has not been subjected to misuse, neglect or unusual

physical, electrical or electromagnetic stress, or some other type of

accident.

(II) No modification, alteration or addition has been made to the Product

by persons other than UBIQUITI NETWORKS or UBIQUITI NETWORK’S

authorized representatives or otherwise approved by UBIQUITI

NETWORKS.

(III) The Product has been properly installed and used at all times in

accordance, and in all material respects, with the applicable Product

documentation.

(IV) All Ethernet cabling runs use CAT5 (or above) shielded cabling.

Disclaimer: UBIQUITI NETWORKS does not warrant that the operation of

the products is error-free or that operation will be uninterrupted. In no

event shall UBIQUITI NETWORKS be responsible for damages or claims

of any nature or description relating to system performance, including

coverage, buyer’s selection of products for buyer’s application and/or

failure of products to meet government or regulatory requirements.

Returns

In the unlikely event a defect occurs, please work through the dealer or

distributor from which this product was purchased.

All Ethernet cabling runs must use CAT5 (or above). It is the customer’s

responsibility to follow local country regulations, including operation

within legal frequency channels, output power, indoor cabling

requirements, and Dynamic Frequency Selection (DFS) requirements.

Compliance

FCC

Changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including

interference that may cause undesired operation.