Quick Start Guide

Upgrade from UAP-PRO
The design of the UAP-AC-PRO Mounting Bracket facilitates
upgrades from the UAP-PRO, by eliminating the need to drill
new holes in the wall or ceiling tile. The following illustrations
show the Mounting Bracket holes that are used for the
UAP-AC-PRO and UAP-PRO:
Mounting Bracket Holes (4)
for UAP-AC-PRO
Mounting Bracket Holes (3)
for UAP-PRO
To begin the upgrade, perform the following steps:
1. Insert a paper clip into the UAP-PRO Locking Notch
to disengage the lock. Then turn the UAP-PRO
counterclockwise and lift it off of the mounting bracket.
Locking Notch
UAP-PRO (wall mount installation)
2. Unscrew the three screws holding the mounting bracket to
the wall or ceiling tile.
3. Go to step 3 of the Wall Mount section or step 4 of the
Ceiling Mount section.