Owners manual

66
UniFi® Controller User Guide
Ubiquiti Networks, Inc.
Chapter 11: UniFi Switch Details
Enable Flow Control Disabled by default. Flow
Control allows the port to manage data rates in case
the sending and receiving devices use different data
transmissionrates.
Apply Click Apply to save changes.
Network
Configure IP Select the Internet connection type for your
service.
• Using DHCP The use of the Dynamic Host
Configuration Protocol (DHCP) is the default. The AP
automatically acquires network settings from the
network’s DHCP server.
• Apply Click Apply to save changes.
• Static IP Assign fixed network settings to the Switch.
Enter the following information:
- IP Address Enter the IP address for the Switch.
- Subnet Mask Enter the subnet mask of the Switch.
- Gateway Enter the IP address of the gateway (for
example, the UniFi Security Gateway).
- Preferred DNS Enter the IP address of the primary
DNS server.
- Alternate DNS Enter the IP address of the secondary
DNS server.
- DNS Suffix Enter the Fully Qualified Domain Name
(FQDN) without the hostname.
• Apply Click Apply to save changes.
Forget This Switch
Forget Click to remove the Switch from
management by the UniFi Controller software and reset it
to factory default settings.
Note: Use caution when clicking Forget. This will
restore the Switch to factory default settings when it
is in a Connected state.
Move to To move the Switch, select another site from the
drop-down menu.