Owners manual

58
UniFi® Controller User Guide
Ubiquiti Networks, Inc.
Chapter 10: UniFi Security Gateway Details
• PPPoE Point-to-Point Protocol over Ethernet (PPPoE)
is a virtual private and secure connection between two
systems that enables encapsulated data transport. Enter
the following information:
- Username Enter the username used to connect to
the PPPoE server.
- Password Enter the password used to connect to the
PPPoE server.
- Preferred DNS Enter the IP address of the service
provider’s primary DNS server.
- Alternate DNS Enter the IP address of the service
provider’s secondary DNS server.
• Apply Click Apply to save changes.
Port Forward
Create Click to add a new entry. Go to the Create
New Entry section in the next column.
Name Displays the name of the port forwarding entry.
From Displays the source IP address, if specified.
Port Displays the port or ports that will be forwarded to
the LAN.
Dest IP/Port Displays the destination IP address and/or
port, which will receive the forwarded port traffic.
Actions Click a button to perform the desired action:
• Edit Click
to edit the port forwarding entry.
• Delete Click
to delete the port forwarding entry.
Create New Entry
Name Enter a name to identify this port forwarding entry.
From The default is Anywhere, which accepts traffic from
any source IP address. To specify a source IP address,
select Limited and enter the source IP address in the field
provided.
Port Enter the port or ports that will be forwarded to the
LAN. You can identify the port or ports by name, number,
and/or range. To specify multiple ports, use a comma-
separated list (example: https, 20-23,554).
Forward IP Enter the LAN IP address that will receive the
forwarded port traffic.
Forward Port Enter the port or ports that will receive the
forwarded port traffic. You can identify the port or ports
by name, number, and/or range. If you do not specify this
port, then the original destination port of the traffic will
beused.
Advanced Options
Protocol Select the protocol that will be forwarded: Both,
TCP, or UDP.
Apply Click Apply to save changes.
Cancel Click Cancel to discard changes.