Owners manual

20
UniFi® Controller User Guide
Ubiquiti Networks, Inc.
Chapter 2: Using the UniFi Controller Software
Upload Audio Upload an audio file (.mp3 or .wav) to use
as your greeting.
• Choose Click Choose to select the appropriate audio
file, and then click Open.
• Cancel Click Cancel to discard changes.
Menu
Add Option When a call is answered, you can have
multiple menu options available. Click to set
up menu options for the Auto-Responder. Then configure
the following:
• Press Select the appropriate keypad number.
• For Select the appropriate action: Transfer or
Voicemail.
• Select one Select the appropriate extension from the
drop-down menu.
Remove Option Click to remove the
appropriate menu option.
Save Click to apply changes.
Settings > Controller
Configure the system settings of the UniFi Controller.
Controller Settings
Controller Hostname/IP Enter the hostname or IP
address of the UniFi Controller.
Note: When alert emails are sent out, the Controller
Hostname/IP will be specified in the Controller URL at
the bottom of every message.
Network Discovery When enabled, this option allows
UniFi to be discoverable via UPnP. This option is disabled
by default.
Mail Server
When enabled, UniFi will send email alerts triggered by
pending and disconnected UniFi devices. Specify the
administrator email address when you create an account
under “Settings > Admins” on page 15.
SMTP Server Select this option to enable emails.
• Enable mail server Enter the outgoing (SMTP) mail
server name.
• Port The default is 25. If Secure Sockets Layer (SSL)
is enabled, then the port number will automatically
change to 465.
• Enable SSL You can enable SSL to enhance secure
communications over the Internet.
• Enable authentication Select this option to enable
authentication.
- Username Enter the username required by the
mailserver.
- Password Enter the password required by the
mailserver.
• Specify sender address Seledct this option to specify
the sender email address. Enter the email address that
will appear as the sender of the email alert.
• Test SMTP Server Enter an email address and click
Send to test the mail server setup.
Apply Click to save changes.